background image

8  

 

   

 

 

TABLE OF CONTENTS 

 
Specifications  ——————————————————  3 
Safety Precautions  ———————————————— 3 
Control Panel Guide  ———————————————  4 

Operating Guidelines  ————————————–—-   5 
Assembly guide —————————-———–————   6 
Care and Maintenance  ———————————–—     7 
 

BlackJack SolderWerks 

BK4000  

Repairing System 

 
 

INSTRUCTION MANUAL 

 
 

Thank you for purchasing the BlackJack BK4000 Repairing System.  

Please read this manual before operating the equipment.   

Keep manual in accessible place for future reference.  

 

NOTE: Please remove the screw located at the center of 

the bottom part of the main unit. This screw holds the 

pumps in place during shipping. Failing to remove this 

screw prior to use can cause damage to the unit

 

Summary of Contents for BK4000

Page 1: ...RUCTION MANUAL Thank you for purchasing the BlackJack BK4000 Repairing System Please read this manual before operating the equipment Keep manual in accessible place for future reference NOTE Please remove the screw located at the center of the bottom part of the main unit This screw holds the pumps in place during shipping Failing to remove this screw prior to use can cause damage to the unit ...

Page 2: ...ng filter Filter barrel body and Filter barrel cap 2 Take out the filter spring or the filter pads for cleaning or replacement 3 Re assemble Filter pipe assembly and place back to the de soldering gun body see illustrations on page 6 4 Push the Filter dock back in place until a click sound is heard signi fying that the filter dock is properly secured Using Cleaning pin Caution Desoldering gun will...

Page 3: ...kage to make sure eve rything is in good condition Do not use item if visible damage is seen report the issue to your vendor Power off unit and unplug the device when moving the device from one location to another Do not subject the main unit to physical shock Never drop or sharply jolt the unit Contains delicate parts that may break if the unit is dropped Always connect power to a grounded recept...

Page 4: ...just knob 4 from the control panel to the appropriate desolder ing temperature Always set the temperature to the lowest possible working temperature 8 Wait a few minutes or until Nozzle is hot enough to melt solder 9 Keep the nozzle clean If the tip of the nozzle is coated with oxide the nozzle s heat conductivity will be lowered 10 Always place the desoldering gun in its holder when not in use 11...

Reviews: