2
3
FIGURE 2 -
USB560bp
USB End Plate
1. Place
the
USB560bp
JTAG Emulator module in desired location
(most likely near the target hardware).
2. Attach the supplied USB cable to an available USB port on the PC
and to the USB connector on the
USB560bp
JTAG Emulator (see
Figure 2).
3. Follow the Plug and Play installation for the Windows device driver
(see section 3 on USB PnP Installation).
4. After PnP installation, attach the emulator pod’s JTAG cable assem-
bly (the female 2x10 header connector in Figure 1) to the correspond-
ing male header on the target board. (pin converter may be required if
connecting to target board with 14-pin, 60-pin or 20-pin ARM male
headers.)
Make sure the target is not powered when connecting!
5. Setup and start Code Composer Studio (see section 4).
Bi-color LED
RED
/
GREEN
USB Cable
Connector
1
Emulation Driver Installation
The
USB560bp
JTAG Emulator shipped with its emulation drivers on CD
ROM media that are needed by Windows and CCStudio for operation.
2
Hardware Installation
WARNING
Be careful to connect interface cables with the correct orientation. Pin 1 on
the interface cable should match Pin 1 on the DSP system connector. The
JTAG cable assembly features a "keyed" connector to minimize the chance
of error.
Do not force cables into position. Forcing them may damage the cables or
the interconnected boards and systems.
1. Insert the Emulation Driver CDROM into your PC’s CDROM drive.
2. Follow the installation wizard, and when done, you are ready to install
the emulator hardware.
If the installation executable fails to start automatically, run X:\Setup\Setup.exe,
where [X] is the drive letter for your CD ROM drive.
USB PnP Installation
3
Windows 2000/XP/Vista
1. If not already connected, connect the USB cable to the
USB560bp
and to
the computer.
2. LED will be
RED
on power up.
3. Follow the Windows “Found New Hardware” wizard prompts.
4. You can select the “automatic” option for locating drivers.
5. If the automatic option did not locate them, you can manually specify the
location.
These files were installed to your system during the Emulation
Driver Installation - section 1. The typical location for these files is
folder:
C:\CCStudio_v3.3\blackhawk\drivers.1
, where
<C:\CCStudio_v3.3>
is the location selected in section 1.
6. When completed, the Blackhawk Control Panel and Windows Device
Manager will show the device. The Blackhawk Control Panel can be acti-
vated from its icon, located in the Windows Control Panel Dialog Box.
7. The LED will be
GREEN
when drivers are loaded correctly.
8. Now follow the Code Composer Studio Setup in section 4.
FIGURE 1 -
USB560bp
JTAG Emulator
8 inch, highly
flexible, coax
ribbon cable
Keyed,
compact TI 20-pin
JTAG target connector
Bi-color LED
RED
/
GREEN
USB Cable
Connector
NEW
