2
3
1
Emulation Driver Installation
1. Power down your computer and open the case to gain access to an
available PCI slot.
2. Install
the
PCI560
board (see Figure 2) making sure to secure the PCI
end plate to the case.
If your PC requires a low profile bracket, one has
been included to easily replace the standard (taller) bracket. Please refer
to the section in the Installation Guide for detailed instructions for replac-
ing the bracket.
3. Attach the JTAG cable assembly to the corresponding “D” connector of
the
PCI560
(see Figure 1).
4. Close the computer case and boot the machine.
5. Follow the Plug-N-Play Found New Hardware Wizard to install device
drivers (see section 3 on PCI PnP Installation).
FIGURE 2 -
PCI560
Installation
Standard
PCI
Bracket
The
PCI560
JTAG Emulator shipped with its emulation drivers on CD ROM
media that are needed by Windows and CCStudio for operation.
1. Insert the Emulation Driver CDROM into your PC’s CDROM drive.
2. Follow the installation wizard, and when done, you are ready to install
the emulator hardware.
If the installation executable fails to start automatically, run X:\Setup\Setup.exe,
where [X] is the drive letter for your CD ROM drive.
2
Hardware Installation
WARNING
Be careful to connect interface cables with the correct orientation. Pin 1 on the
interface cable should match Pin 1 on the DSP system connector. The JTAG
cable assembly features a "keyed" connector to minimize the chance of error.
Do not force cables into position. Forcing them may damage the cables or
the interconnected boards and systems.
PCI PnP Installation
3
Windows 2000/XP/Vista
1. Make
sure
the
PCI560
Emulator is installed.
2. Boot the computer and log in.
3. Follow the Windows “Found New Hardware” wizard prompts.
4. You can select the “automatic” option for locating drivers.
5. If the automatic option did not locate them, you can manually specify the
location.
These files were installed to your system during the Emulation
Driver Installation - section 1. The typical location for these files is
folder: C:\CCStudio_v3.3\blackhawk\drivers.1 , where
<C:\CCStudio_v3.3> is the location selected in section 1.
6. When completed, the Blackhawk Control Panel and Windows Device
Manager will show the device. The Blackhawk Control Panel can be
activated from its icon, located in the Windows Control Panel Dialog Box.
7. Now follow the Code Composer Studio Setup in section 4.
“D” connector
Low-profile PCI Bracket
FIGURE 1 -
PCI560
with XDS560 JTAG Cable and Pod Assembly
