2
3
USB PnP Installation
3
The
LAN560
JTAG Emulator shipped with its drivers on CDROM media that are
needed by Windows and Code Composer Studio for operation.
WARNING
Be careful to connect interface cables with the correct orientation. Pin 1 on the inter-
face cable should match Pin 1 on the DSP system connector. The JTAG cable as-
sembly features a "keyed" connector to minimize the chance of error.
Make sure the target is
not powered
when connecting!
2
Hardware Installation
1
Emulation Driver Installation
Important Caveat
When using the
LAN560
JTAG Emulator via its USB port to debug target hard-
ware with Code Composer Studio, it will use the same settings as the
USB560m
JTAG Emulator. The
LAN560
is designed to setup and operate the same as the
USB560m
when using the USB port to debug.
1. Insert the Emulation Driver CD.
2. Follow the installation wizard, and when done, you are ready to install the emula-
tor hardware.
1. Place
the
LAN560
module in desired location.
2. Connect the 5v DC power plug of the power supply to the 5-volt DC input on the
LAN560
(see figure 1).
3. Attach the USB cable to an available USB port on the PC and to the USB connec-
tor on the
LAN560
(see figure 1).
4. If not already connected, attach the JTAG cable assembly to the corresponding
“D” connector of the
LAN560
(see figure 2).
5. Connect the power supply A/C wall cord to A/C power, which will power the
LAN560
and initiate Plug and Play installation for the Windows device driver (see
step 3 on USB PnP Installation).
6. Follow the Windows Plug and Play Found New Hardware Wizard Installation for
the Windows Device Driver (see step 3 on USB PnP Installation).
NOTE
If the installation executable fails to start automatically,
run X:\Setup\Setup.exe,
where [X] is the drive letter for your CDROM drive.
FIGURE 1—LAN, USB & Power Endplate
FIGURE 2—JTAG End Plate
5V DC Input
High-speed USB
Cable Connection
Separate Status
and Activity LED’s
Windows 2000/XP/Vista
1. Make
sure
the
LAN560
Emulator is powered.
2. Connect the USB cable to the emulator and to the computer.
3. Follow the Windows “New Hardware” prompts selecting the location
where the Blackhawk USB device drivers exist.
These file were in-
stalled to your system during the Emulation Driver Installation—
section 1. Typical location for these files is folder:
C:\CCStudio_v3.3\blackhawk\drivers.1\LAN.
4. When completed, the Blackhawk Control Panel and Windows Device
Manager will show the device. The Blackhawk Control Panel can be
activated from its icon, located in the Windows Control Panel Dialog
Box.
5. Now follow the Code Composer Studio Setup—Section 4
RJ45 Ethernet
Port
JTAG Cable
Connection
“D” Connector
