2
3
CCS Configuration
3
2
Cable Connections
1. If attached, detach the 14-pin and 20-pin ribbon cables from the XDS110 de-
bug probe’s AUX and DEBUG connectors.
2. Attach the supplied two inch 20-pin and 14-pin ribbon cables (if not already
attached) to J1 and J2 of the
ISO110
board respectively (see figure 1).
3. Attach the other end of the 20-pin and 14-pin ribbon cables to the correspond-
ing XDS110 AUX and DEBUG connectors (see figure 1).
4. Attach the XDS110’s 20-pin JTAG ribbon cable to J3 of the
ISO110
.
5. Attach the other end of the XDS110’s 20-pin JTAG cable to your target board.
6. The stand-offs are optional and attach to the holes shown in figure 4 to prevent
the PCB from touching the bench or table underneath as needed.
FIGURE 1 - ISO110 Cable Connections
Step 2: 20-pin & J1
Step 2: 14-pin & J2
Step 3: 14-pin & AUX
Step 3: 20-pin & DEBUG
Step 4: 14-pin & J2
Step 5: 20-pin &
Target board
To use the
ISO110
with Code Composer Studio, you need to configure the
XDS110 Debug Probe setting to output 3.3v on the AUX connector. The
steps below describe how to accomplish this using the CCS target configura-
tion dialog. This assumes that you already followed the steps in section 2.
Please refer to figure 2 below when following these steps.
A. Start Code Composer Studio.
B. Edit your current XDS110 target configuration or create a new one
(
File >
New > Target Configuration File
)
for XDS110 and your target device.
The example in figure 2 uses the XDS110 and an F28379D device.
C. Select the
Advanced
tab in the target configuration.
D. Select the XDS110 Debug Probe in the
All Connections
tree view.
E. Select
Probe supplied power
option in the
Power Selection
of the
Connection Properties
.
F. This will display a voltage field text box where you will enter
3.3
.
G. Save the setup by pressing the
Save
button.
Now you are ready to launch the debug session.
FIGURE 2 - CCS Target Configuration
C
B
D
E
F
G
All manuals and user guides at all-guides.com
