8
Note: PIR is not supplied as standard.
Your Period Telephone is designed to
allow for activation via PIR sensor (sold
separately). When connected via the PIR
input on the Control Box, the phone will
be activated upon sensing movement.
When in PIR mode the ‘Delay’ setting will
no longer cause the phone to ring
automatically every set period of time, but
will instead determine how often the PIR
will trigger the phone.
For example, if the time is set to 1 minute
the PIR will have to wait 1 minute after the
phone is triggered in order to trigger it
again.
Note: When device is first powered up the
PIR takes 30 seconds to settle before it
becomes active.
As standard the Period Telephone Control Box will power a 5V PIR, however this can be
changed to 12V. The changeover can be made by moving a jumper located on the
board. To access the board, you must unscrew the rear plate and the board can slide
out. The jumper is located near the PIR input. Please refer to the steps below;
1.
First locate the jumper
2.
Move the jumper from its original
position on the right (5V) to the 12V
position on the left.
Summary of Contents for Period Telephone
Page 1: ...1 V2 ...
Page 11: ...11 ...
