E Z - 1 Q U A D R I B E N T A S S E M B L Y A N D U S E R G U I D E
10
Check proper operation of the brakes, front and rear
shifters after Quadribent is fully assembled. Test ride
to verify adjustments.
DO NOT ALLOW ANYONE TO STAND OR
SIT ON ANY OF THE QUADRIBENT
CONNECTING PARTS OR TO RIDE
ANYWHERE EXCEPT ON THE SEAT.
20) The final assembly step is the installation of the
seatbelts. Unclip or open the lower two seat back
mounting clips from the EZ-1 koolback seat.
Thread the end of the seatbelt through the tri-glide
fastener and then around the exposed seat frame as
shown in figure 20.
Figure 20
21) Insert the end of nylon strap back through the
tri-glide as shown in figure 21.
Figure 21
22) Insert the end of nylon strap back through the
tri-glide as shown in figure 22. Reconnect the middle
two seat back mounting buckles on the EZ-1 seat.
Repeat this process on both the right and left side of
each seat on each bike.
Figure 22
23) Install the other end of the nylon straps through
the buckle as shown in figure 22. The buckle is
equipped with a quick release. Simply squeeze the
center of the buckle and it will open. Seat belt length
is adjustable by pulling on the ends of the nylon
straps. If the strap end becomes frayed it can be
sealed with a flame from a candle
.
Figure 23
www.blackbirdbikes.com