7
4-Pin White Connector A:
Plug-in connector
port for dual stage shock sensor.
4-Pin White Connector B:
Plug-in connector
port for optional dual stage radar sensor.
Adding Transmitters
To add a new transmitter to the system have
the desired transmitters ready and follow
the Code Learning sequence.
To enter Code Learning Mode:
1. Turn the ignition on, off, on, off and leave
on.
• The siren will chirp once.
2. Press and hold the Valet switch for 5
seconds.
• The siren will chirp 3 times.
3. Press the Lock Button on the
transmitter.
• The siren will chirp once.
4. Press Lock Button on the transmitter
again.
• The siren will chirp twice.
5. Repeat steps 3 and 4 for each additional
transmitter (up to 4 total).
6. Turn off the ignition.
• The siren will chirp 3 times.
Two Car Operation
With the supplied 5-button transmitter it is
possible to control a second vehicle using
the same primary transmitter. For Car 2
enter the Code Learning Mode as described
above then substitute the steps below for 3
and 4 above.
3. Press Button 5 twice followed by the
Lock Button.
• The siren will chirp once.
4. Press Button 5 twice followed by the
Lock Button again.
• The siren will chirp twice.
Entering Programming
To enter System Programming:
1. Turn on ignition.
2. Within 5 seconds, press valet switch 5
times.
• The siren will emit a long chirp, to
indicate entering program mode.
3. Press the valet switch the number times
equal to the desired feature.
• The siren will chirp each time the valet
switch is pressed. A long chirp is equal
to 5 presses. (Example: step 7 = 1 long
chirp and 2 short chirps.)
4. Within 5 seconds, press the transmitter
button corresponding to the desired
operating mode for that feature.
• The siren will chirp to indicate the
setting.
One chirp = Button 1
Two chirps = Button 2
Three chirps = Button 3
Four chirps = Button 4
5. Repeat steps 3 and 4 to change
additional features.
6. Turn off ignition to save changes.
Complete Default Reset
This procedure will set all Programmable
Features to factory default settings.
1. Enter System Programming.
2. Press Transmitter Button 3.
• The siren will chirp 6 times indicating
the reset signal was received.
• All Installer and User Programming
options are now set to factory default
settings.
3. Turn ignition off.
BW3750 new size.qxd 4/14/2004 9:09 AM Page 7
