3
Summary of Inputs and outputs:
Inputs:
Outputs
1 Sensor port-4 wire (w/warn away)
Siren output: 3 amp Max - positive
1 Sensor port -3 wire
Flashing lights: relayed - 15 amp Max
Negative door trigger
Starter Interrupt: relayed:40 amp (N.C.)
1 Negative hood/trunk trigger
Dome Light: relayed- 15 amp Max
1 Positive door trigger
Door lock/unlock : 500 ma -negative
Door lock/unlock: relayed* 15 amp max
2 nd Channel: 500 ma- negative
3rd Channel: 500 ma - negative
*Module with door lock relays on board
Armed Output: 250 ma - negative
Dip Switch Programmable Features:
Switch #1= Lock/Unlock Pulse Time:
ON= .75 seconds
OFF= 3 seconds
Switch #2= Ignition Triggered Door Locks: ON= Feature On
OFF= Feature OFF
Switch #3= Passive Door Locks:
ON= Feature On
OFF= Feature OFF
Switch #4= Passive or Active Arming:
ON= Passive Arm
OFF= Active Arm
the 2nd channel is used for opening the
trunk or hatch, the alarm (if armed) will
automatically disarm.
To program these specific features
follow the procedure below:
1.Turn ignition key to the ON position
2. Press the valet switch 5 times (siren will
give long chirp).
3.Then select the program that you wish
to change and press the valet switch the
same number of times.The siren will
chirp each time you press the switch.
4. Press button one or two on the trans-
mitter to change to the desired program
to the feature.
Example: Programming the 3rd channel to
horn output.
1. Ignition Key On,
2. Press Valet switch 5 times
3. Siren will give long chirp,
4. Next, press Valet switch 3 times, siren will
chirp after each time you press the switch
5. Press button #2 on transmitter
6.Turn ignition key off.The red/white wire on
the main harness now is programmed to be
