-
1
-
INSTALLATION INSTRUCTIONS
I
MPORTANT: Make all wiring connections to the vehicle before connecting the main
14-pin connector harness to the receiver and control module.
1.
Before
mounting the BWS-1152 Receiver and Control Module, you must set the PROGRAMMING DIP-
SWITCHES for the kind of operation the customer wants.
These are the switch settings available;
Standard (Default) settings are in
“BOLD”
type:
Switch #1
Door Lock and Unlock Pulse Time: ON = 3/4 seconds. OFF = 3 seconds.
Switch #2
Door Lock and Unlock with ignition: ON = YES. OFF = NO.
Switch #3
Door Locking with Passive Arming: ON = YES. OFF = NO.
Switch #4
Passive or Active Arming: ON = Passive Arming. OFF = Active Arming.
2.
Mount the Receiver and Control Module
in a secure area, away from vehicle computers and heating/air condi-
tioning ducts.The location should be convenient for your installation, but well hidden from thieves.Try to mount the unit
as far away from metal objects as possible.This will increase the range of its Remote Control Transmitter.
3.
Route the wires of the harnesses
to areas in which the different accessories will be mounted .You may
need to extend some wires. DO NOT plug the two wiring harnesses into the Receiver and Control
Module until all connections have been completed.
When running the harness wires through the vehicle, be careful to run them where they CANNOT be DAM-
AGED or SHORTED to GROUND or other WIRING. Keep them away from ALL MOVING PARTS of the vehicle
or where HIGH HEAT can damage their insulation.Always protect the harness wires where they pass through
holes in metal panels by using RUBBER GROMMETS.
4.
Mount the MTS-20W Siren
under the vehicle’s hood. Mount it away from heat sources such as radiators,
exhaust manifolds, and turbochargers. Mount it in an area where it will not be in the way for mechanics, and so
that it cannot be easily reached from below the vehicle. Mount it so that its opening points down to prevent it
from collecting water, snow, or ice. Connect its BLACK wire to a good clean GROUND point, and its RED wire to
the ORANGE wire of the main harness.
5.
Mount the BWS-296 Shock Sensor
Somewhere inside the vehicle such as under the dash, strapped to the
steering column, or under a seat.
Do Not Mount The Sensor Under The Hood!
Connect its BLACK wire to a good, clean GROUND point, its RED wire to a source of CO12vdc, and
its BLUE wire to the BLUE wire of the main harness.
6.
Mount the BWS-180 LED Status Indicator
in an easily seen location such as the center of the dash or the
inside top edge of the driver’s or passenger’s door. Connect its RED wire to a source of CO12vdc, and
its BLACK wire to the RED/BLACK wire of the main harness.
7.
Install the BWS-260 Valet/Override Switch
in a hidden location that is easily reached by the driver.
Remember that the code learning and valet/override sequence require using this switch in conjunction with the
ignition switch, so it should be hidden, but convenient to use when needed.
8.
Mount and connect any optional function modules
included in the installation, following the mounting
and wiring directions supplied with them.
