Black Widow Security 6150, Installation Manual

Page: 7 / 16

7
Complete Default Reset
Following this procedure will set all User and
Installer Programming Parameters to factory
default settings.
1. Enter System Programming.
2. Press Transmitter Button 3.
• The siren will chirp 6 times indicating the
reset signal was received.
• All Programming options are now set to
factory default settings.
3. Turn ignition off.
Test System and Adjust Shock Sensor
Arm, disarm, and start the system, checking that
the siren and parking lights are functioning nor-
mally. Make sure that the programmed features
are performing correctly, ie.: ignition locks, pas-
sive arming, passive locks, etc.
Test the doors and hood/trunk inputs (make
sure all doors trigger the system.
Adjust the shock sensor. (see Real-time Sensor
Adjustment Mode)
Arm the system and disarm it with the ignition
and valet switch.
If programmed to passively arm make sure that
the system arms properly.
Tie up wire harness, and replace any under dash
panels.
Make sure the customer has physical knowledge
of the location of the valet/override switch.
Real-time Sensor Adjustment Mode
This mode allows active testing of the shock sen-
sor and optional sensor input making adjust-
ments without arming the alarm. NOTE: Arm
and Disarm chirps must enabled for proper
operation. Sensor Adjustment Mode does not
operate with the optional FM transmitter.
To enter Sensor Adjustment mode:
1. Turn the ignition on.
2. Press the Shift Button (Button 5) 3 times,
then Button 3.
• The siren will chirp 4 times, indicating that
the sensor is ready to be tested.
3. Test the sensitivity. The siren will chirp to
indicate a sensor is triggered.
• One chirp indicates the shock sensor.
• Two chirps indicates the warn away.
• Three chirps indicates the optional sensor.
4. To make shock sensor adjustments:
• Turn the adjustment screw on the sensor
clockwise to increase the sensitivity.
• Turn the adjustment screw on the sensor
counter clockwise to decrease the sensi-
tivity.
5. Turn off the ignition when the desired sensi-
tivity level is reached.
Adding Transmitters
To add a new transmitter to the system have the
desired transmitters ready and follow the Code
Learning sequence.
To enter Code Learning Mode:
1. Turn the ignition on, off, on, off and leave on.
• The siren will chirp.
2. Press the Override switch.
• The status LED will turn on red.
• The siren will chirp.
3. Press the Lock Button on the transmitter.
• The siren will chirp once.
4. Press Lock Button on the transmitter again.
• The siren will chirp twice.
5. Repeat steps 3 and 4 for each additional
transmitter.
6. Turn off the ignition.
• The siren will chirp 3 times.