4
Battery Replacement/Storage
Replacement:
If operation of the wall receiver units becomes erratic, it may be necessary to replace the battery in the hand-held
remote sending unit. To do this, first remove the battery compartment safety screw with a # 3 Phillips screwdriver and slide the
battery compartment cover off. Next, remove the depleted battery and discard according to local ordinances. Be sure to correctly
reinstall the new battery. The negative (-) end of the battery (marked on the battery label) is inserted into the battery compartment
first toward the spring marked with the negative (-) symbol indicated in the battery compartment. Slide positive (+) end of battery
down next; into the battery compartment. Replace battery compartment cover by sliding into place. Reinstall the safety screw.
Replace with Type 23A 12V battery only.
Storage:
If the hand-held remote control is to be stored and unused for an extended amount of time
– 3 months or longer; it is
recommended that the battery be removed. Follow the instructions for battery replacement and once removed, store the battery in
a secure location. When the hand-held remote control is put back into use, reinstall the battery. There is no guarantee for battery
life. If reinstalled battery fails to operate units correctly, user must replace battery with Type 23A 12V battery.
FCC Notices:
Warning: Changes or modifications to this unit not expressly appr
oved by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions : (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
30 Day Limited Warranty
This product (battery excluded) is warranted to the original purchaser for a period of 30 days from date of purchase. Proof of
purchase is required to obtain warranty service. Warranty is for replacement only. No service parts are available for these
products. No other warranties are expressed or implied. Batteries, battery life or battery power cycles are not covered under this
warranty. For warranty service, please contact Blackstone International Customer Service: 1-888-525-7969 or
. Monday
– Friday 8:30 AM – 5:00 PM. English Only.
Remove Safety Screw with # 3 Phillips Screwdriver
Slide Battery Cover Out.
Remove Battery
Install New Battery
Reinstall Battery Cover and Safety Screw
Battery Cover Removed Showing Battery
(Type 23A 12V) and Battery (-) and (+)
Indicators Inside Battery Compartment.
When installing new battery be sure to
install negative (-) end first followed by
positive (+) end.
