MAX T BULL BAR FOR 2019-2020 Dodge Ram 1500 (BMR15)
Page 8 of 9
Stand back from the vehicle and check to see that the Guard is centered and level on the vehicle
and adjust as necessary. Fully tighten first the hardware securing the Mounting Brackets to the
vehicle. Next tighten only the (4) 8mm Hex Bolts securing the Tube Brackets to the Guard as
described in Step 7. Do not tighten the 12mm hardware attaching the Tube Brackets to the
Mounting Brackets. Temporarily remove the Guard with Tube Brackets attached.
Hold the plastic air dam up to the bumper and align it with the mounting points. Mark the location of
the Mounting Brackets onto the back of the air dam, (Fig 8). Cut an approximately 1-1/2" wide slot
out of the bottom of the air dam.
NOTE:
The size of the slot is an estimate only and may vary due to different factory designs for the
air dam and front bumper covers.
MPORTANT:
To avoid weakening the air dam, do not cut the slot any larger than necessary to clear
Brackets only. Do not cut through the top edge or mounting points, (Fig 8). Make several small cuts
first and check the fit often for a clean installation.
STEP 9:
STEP 10:
(Fig 7) Attach Guard to Mounting Brackets
Front
(2) 12mm x 35mm Hex Bolt
(4) 12mm Flat Washers
(2) 12mm Lock Washers
(2) 12mm Hex Nuts
