TRAVEL AIR.
INSTRUCTION MANUAL
19
Tie wrap.
Tie wrap.
Battery.
1) Assemble and mounting the wheel pants
as shown in the following pictures.
MAIN GEAR INSTALATION.
PARTS REQUIRED
Receiver.
INSTALLING THE RECEIVER AND BATTERY.
1. Plug the servo leads and the switch
lead into the receiver. You may want to plug
an aileron extension into the receiver to make
plugging in the aileron servo lead easier
when you are installing the wing . Plug the
battery pack lead into the switch.
2. Wrap the receiver and battery pack in
the protective foam to protect them from
vibration. Use a rubber band or masking tape
to hold the foam in place.
3. Position the battery pack and receiver
behind the fuel tank. Use sing to two tie wraps
to hold the battery and receiver securely in
place as picture below.
Do not permanently secure the receiver and
battery until after balancing the model.
4. Using a 2mm drill bit, drill a hole through
the side of the fuselage, near the receiver, for
the antenna to exit.
