5
SUPER AIR- Item code
BH05-A.
Instruction Manual
3. Drill 1,5mm pilot holes through the block
of wood for each of the four mounting screws
provided with the servo. Install servo into ai-
leron servo tray as same as picture below.
4. Using the thread as a guide and using
masking tape, tape the servo lead to the end
of the thread: carefully pull the thread out.
When you have pulled the servo lead out, re-
move the masking tape and the servo lead
from the thread.
Temporary pin to
keep hinge centered.
Servo tray.
2. Using a modeling knife, remove the cov-
ering servo tray.
Aileron
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
5. Instal servo tray with aileron servo into
the wing as same as picture below.
Electric wire.
Servo tray.
Wing.
2x10mm.
