Black Horse Model Sea Fury BH113, Instruction Manual Book

Page: 3 / 30

3
SEA FURY -
Item code:BH113 INSTRUCTION MANUAL.
Caution: this model is not a toy!
If you are a beginner to this type of powered model, please ask an experienced model flyer for help and
support. If you attempt to operate the model without knowing what you are doing you could easily injure
yourself or somebody else. Please keep your safety and well-being in mind at all times.
Important: before you start construction
Even if you have already built a large number of RC models please read right through these instructions and
check all the kit components against the parts list. We have taken great trouble to keep construction as
simple as possible, without making any compromises in the area of safety.
Note regarding the film covering
Minor creases or bubbles may develop in the film covering due to major fluctuations in weather conditions
(temperature, humidity etc.); in rare cases you may even find a slight warp in a component. These minor
faults are in the nature of film-covered built-up wooden structures, and can easily be corrected using a heat
gun, as commonly used for modelling.
Creases:
Blow warm air over the area and rub down with a soft cloth.
Wing warp: Hold the panel twisted gently in the opposite direction to the warp, and apply warm air to
remove the creases from the covering.
Caution! do not heat the film more than is absolutely necessary. If the air or the iron is too hot, the film may
melt and holes may be formed.
This model is highly pre-fabricated and can be built in a very short time. However, the work which you have to
carry out is important and must be done carefully. The model will only be strong and fly well if you complete
your tasks competently - so please work slowly and accurately.
When self-tapping screws have to be screwed into wood, apply a little white glue to prevent them
shaking loose: just squirt white glue into the hole and fit the screw.
SAFETY PRECAUTION.
REPLACEMENT LARGE PARTS
+ This is not a toy
+ Be sure that no other flyers are using your radio frequency.
+ Do not smoke near fuel
+ Store fuel in a cool, dry place, away from children and pets.
+ Wear safety glasses.
+The glow plug clip must be securely attached to the glow plug.
+ Do not flip the propeller with your fingers.
+ Keep loose clothing and wires away from the propeller.
+ Do not start the engine if people are near. Do not stand in line with the side of the propeller.
+ Make engine adjustments from behind the propeller only. Do not reach around the spinning
propeller.
A
F1
D2
B2
B1
C
D1
E.
A.Cowling.
B. Wing panel (B1,B2).
C. Fuselage.
D. Horizontal stabilizer.
E. Rudder
F2. Aluminium wing
dihedral brace.
F1. Aluminium tube
Horizontal stabilizer.
F2