OV-1 MOHAWK.
INSTRUCTION MANUAL.
23
Bottom side of elevator.
C/A glue.
Put the vertical stabilizer back in place.
Using a triangle, check to ensure that the
vertical stabilizer is aligned 90 degree to the
horizontal stabilizer.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
When you are sure that everything is a
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
slot in the mounting platform and to the ver-
tical stabilizer mounting area. Set the sta-
bilizer in place and re-align. Double check
all of your measurements once more be-
fore the epoxy cures. Remove any excess
epoxy using a paper towel and rubbing al-
cohol and hold the stabilizer in place with T-
pins or masking tape. Allow the epoxy to fully
cure before proceeding.
Push.
Epoxy glue.
C/A glue.
Pen.
Top side of the elevator.
Fiberglass cover end bottom fuselage.
