4
NOORDUYN NORSEMAN Item code: BH157
.
Instruction Manual
REPLACEMENT SMALL PARTS
1. INSTALLINg THE AILERONS
I. AILERON
Assemble then apply drops of thin
C/A to center of hinge,on both sides.
Temporary pin to
keep hinge centered.
Test fit the ailerons to the wing with the hinges. If the
hinges don’t remain centered, stick a pin through the
middle of the hinge to hold it in position.
See pictures below:
2. INSTALLINg THE AILERON SERVOS
1)
Install the rubber grommets and brass
eyelets on to the aileron servos.
2)
Using a modeling knife, remove the
covering from over the pre-cut servo arm exit hole on
the aileron servo tray / hatch. This hole will allow the
servo arm to pass through when installing the aileron
pushrods.
Servo tray
Remove the covering
Aileron
Flap
Bottom side.
2x10mm
1. Plastic fairing
for landing gear (1a, 1b).
2. Wheels.
3. Tail gear set.
4. Plywood of wing struts.
5. Fuel Tank.
5a. Clunk.
5b. Stopper (three line).
6. Plastic - engine mount.
7. Wood - motor mount.
3x12mm
5
5a
5b
7
3x15mm
4x60mm
4x25mm
3x25mm
6
3x15mm
3x8mm
3
3x12mm
4
4x15mm
5x35mm
2
1a
1b
1a
1b