KATANA.
INSTRUCTION MANUAL
13
1. Set the tail wheel assembly in place
on the plywood plate. The pivot point of the
tail wheel wire should be even with the rud-
der hinge line and the tail wheel bracket should
be centered on the plywood plate.
2. Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
Secure
.
SERVO INSTALLATION
ELEVATOR INSTALLATION
1. Install the rubber grommets and brass
collets into the elevator servo. Test fit the servo
into the servo tray.
2. Mount the servo to the tray using the
mounting screws provided with your radio
system.
3. Secure the tail wheel bracket in place
using three 3mm x 12mm wood screws. Be
careful not to overtighten the screws.
Remove the covering
Right side
Left side
Summary of Contents for KATANA bh27
Page 27: ...KATANA INSTRUCTION MANUAL 27...
