20
GILMORE-
Item code:BH62.
INSTRUCTION MANUAL
4. Now, remove the rudder and using a
modeling knife, carefully cut just inside the
marked lines and remove the film of the rud-
der. Just as you did with the horizontal stabi-
lizer, make sure you only press hard enough
to cut the film, not the balsa rudder.
Also carefully remove the covering from
below the lines as you drew as same picture
below.
Remove covering
C/A glue
2. Mark the shape of the vertical on the left
and right side of the rudder on to the horizon-
tal stabilizer using a felt-tip pen.
1. Put the rudder into the fuselage as same
as picture below.
3. Put the vertical stabilizer back in
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90 de-
gree to the horizontal stabilizer.
C/A glue
Mark point
