EDGE 540-V3-
ITEM CODE: BH91.
INSTRUCTION MANUAL
19
C/A glue
Elevator control horn install as same as the
way of aileron control horn. Please see pic-
tures below.
ELEVATOR CONTROL HORN
INSTALLATION.
epoxy cures. Remove any excess epoxy us-
ing a paper towel and rubbing alcohol and hold
the stabilizer in place with T-pins or masking
tape.
5. When you are sure that everything is
aligned correctly, mix up a generous amount
of 30 minute epoxy. Apply a thin layer to the
top and bottom of the stabilizer mounting area
and to the stabilizer mounting platform sides
in the fuselage. Slide the stabilizer in place and
re-align. Double check all of your measure-
ments one more time before the
Epoxy glue
C/A glue
6. After the epoxy has fully cured, remov
the masking tape or T-pins used to hold the
stabilizer in place and carefully inspect the
glue joints. Use more epoxy to fill in any
gaps that were not filled previously and
clean up the excess using a paper towel and
rubbing alcohol.
C/A glue
3mm x 40mm.
Nilon control clasp
.
M3 lock nut.