PIPER CUB.
INSTRUCTION MANUAL
11
2. While keeping the back edge of the
cowl flush with the marks, align the front of
the cowl with the crankshaft of the engine. The
front of the cowl should be positioned so the
crankshaft is in
nearly
the middle of the cowl
opening. Hold the cowl firmly in place using
pieces of masking tape.
Bottom side
3 x 10mm
Right side
Left side
4. Install the muffler and muffler extension
onto the engine and make the cutout in the
cowl for muffler clearance. Connect the fuel
and pressure lines to the carburetor, muffler
and fuel filler valve.
3.
Slide the cowl back over the engine
and secure it in place using four wood screws.
See picture below.
1. Install one adjustable metal connector
through the third hole out from the center of
one servo arm, enlarge the hole in the servo
arm using a 2mm drill bit to accommodate the
servo connector. Remove the excess mate-
rial from the arm.
After installing the adjustable metal con-
nector apply a small drop of thin C/A to
the bottom nut. This will prevent the con-
nector from loosening during flight.
Servo arm.
Connector.
INSTALLING THE THROTTLE PUSHROD.
