Connectors are installed the same way as the t
(see page 15).
hrottle
Instruction manual
WESTLAND LYSANDER Item code: BH170
Rudder servo
Fuselage top side
Connector
Rudder servo
Rudder
Rudder servo
90
o
Connector
Rudder pushrod
INSTALLING THE SWITCH
1)
2)
3)
The switch should be mounted on the fuselage
side, opposite the muffler, close enough to the
receiver so the lead will reach. Use the face plate
of the switch cut out and locate the mounting
holes.
Cut out the switch hole using a modeling knife.
Use a 2mm drill bit and drill out the two mounting
holes through the fuselage side.
Secure the switch in place using the two
machine screws provided with the radio system.
1)
2)
Plug the servo leads and the switch lead into
the receiver. You may want to plug an aileron
extension into the receiver to make plugging in the
aileron servo lead easier when you are installing
the wing. Plug the battery pack lead into the
switch.
Wrap the receiver and battery pack in the
protective foam to protect them from vibration. Use
a rubber band or masking tape to hold the foam in
place.
Do not permanently secure the receiver and
battery until after balancing the model.
INSTALLING THE
RECEIVER AND BATTERY.
SWITCH,
23
