SBACH 342 Item code: BH174
Instruction Manual
1. The switch should be mounted on the fuselage
side, opposite the muffler, close enough to the
receiver so the lead will reach. Use the face plate
of the switch cut out and locate the mounting
holes.
2. Cut out the switch hole using a modeling knife.
Use a 2mm drill bit and drill out the two mounting
holes through the fuselage side.
3. Secure the switch in place using the two machine
screws provided with the radio system.
!
1. Plug the servo leads and the switch lead into the
receiver. You may want to plug an aileron
extension into the receiver to make plugging in the
aileron servo lead easier when you are installing
the wing. Plug the battery pack lead into the
switch.
2. Wrap the receiver and battery pack in the protective
foam to protect them from vibration. Use a rubber
band or masking tape to hold the foam in place.
Do not permanently secure the receiver and battery
until after balancing the model.
Must be purchased
separately!
4mm Washer
4
4
4
4
4mm Spring Washer
M4 Blind Nut
M4 Blind Nut
White glue
4
M5 Blind Nut
4 x 60mm Cap Screw
10 x 40mm Aluminum
4
4
12 x 70mm Aluminum
16 x 5mm Rubber Washer
4
16 x 5mm Flat Washer
4
INSTALLING THE RECEIVER AND BATTERY
INSTALLING THE SWITCH
Receiver
Foam Pad
Tape
Battery
Battery
Switch
Switch
Off
On
Off
On
INSTALLING THE ELECTRIC MOTOR (EP VERSION)
39
Summary of Contents for BH174
Page 17: ...SBACH 342 Item code BH174 Instruction Manual 4 x 15mm 4 x 15mm 17 Bottom view Bottom view...
Page 26: ...SBACH 342 Item code BH174 Instruction Manual 3 x 15mm 3mm 26 Bottom view...
Page 27: ...SBACH 342 Item code BH174 Instruction Manual Spring 27 Bottom view Bottom view...
Page 38: ...SBACH 342 Item code BH174 Instruction Manual 3x12mm Tp Screw 38...
