BUCKER BU 131 JUNGMANN
Item code: BH160
RUDDER CONTROL HORN,
INSTALLATION
PUSHROD
Rudder control horn install as same as method of
elevator control horn.
Rudder pushrod install as same as the way of elevator
pushrod. Please see pictures below.
6mm
90
o
Mark
Control horn
Silicone Tube
Rudder
M2
Pushrod
Rudder
control horn
Rudder pushrod
A+B
glue
Epoxy
Rudder pushrod
Silicone
Tube
Flaslink
Pushrod wire
servo arm
Rudder pushrod
Snap keeper
Rudder servo
1)
Set the tail wheel assembly in place on the plywood
plate. The pivot point of the tail wheel wire should be
even with the rudder hinge line and the tail wheel
bracket should be centered on the plywood plate.
10. MOUNTING THE TAIL WHEEL BRACKET
3mm Collar
2)
Mark the locations of the two mounting screws.
Remove the tail wheel bracket and drill 2mm pilot holes
at the locations marked.
M2
Nut
1000mm Push rod
- - 1
- - - 1
- - 1
- - - - -
Horn
- - - - - 1
- - - - 1
Flaslink
- - - - - 1
5mm Silicone Tube
- - 1
- - - - -
3mm Colar
3 x 15mm Screw
- - - - - 2
- - 2
- - - - -
13
A+B Epoxy glue
Fuselage
side
Bottom
