20
SPEED AIR-40 _
Item code:BH08.
Instruction Manual.
Remove
covering.
Mark pen.
Remove
covering.
2) Slide the vertical stabilizer into the slot
in the top of the fuselage. The bottom edge of
the stabilizer should also be firmly pushed
against the top of the horizontal stabilizer.
3) While holding the vertical stabilizer
firmly in place, use a pen and draw a line on
each side of the vertical stabilizer where it
meets the top of the fuselage.
5) Slide the vertical stabilizer back in
place. Using a triangle, check to ensure
that the vertical stabilizer is aligned 90 de-
gree to the horizontal stabilizer.
90º
Vertical
Stabilizer.
Horizontal
Stabilizer.
4) Now, remove the vertical stabilizer and
using a modeling knife, carefully cut just in-
side the marked lines and remove the film of
the vertical stabilizer. Just as you did with the
horizontal stabilizer, make sure you only press
hard enough to cut the film, not the balsa ver-
tical stabilizer.
When cutting through the covering to re-
move it, cut with only enough pressure to only
cut through the covering itself. Cutting into
the balsa structure may weaken it.
Remove covering.
Epoxy glue.
All manuals and user guides at all-guides.com
