FAIREY ALBACORE
Item code: BH166
5. INSTALLING THE FUSELAGE SERVOS
1) Install the rubber grommets and
brass collets into the elevator, rudder
and throttle servos. Test fit the servos
into the servo tray. Trim the tray if
necessary to fit your servos.
2) Mount the servo to the tray using
the mounting screws provided with
your radio system.
INSTALLING THE THROTTLE PUSHROD
* Install one adjustable metal connector through the third hole out from the center of one servo arm, enlarge the
hole in the servo arm using a 2mm drill bit to accommodate the servo connector. Remove the excess material from
the arm.
After installing the adjustable metal connector apply a small drop of thin C/A to the bottom nut. This will
prevent the connector from loosening
during flight.
Throttle servo
Connector
Servo arm
Cut
Secure
Throttle pushrod
Fuselage bottom side
Rudder servo
Elevator servo
11
Zip tie
Fuel tank
Throttle servo
Fuselage top side