XPS PRO 1000 User Guide
Edition 1.02
41
. . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
RS-232
AND
10/100T P
ROTOCOL
A
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
X P S P R O 1 0 0 0 C O M M A N D S E T
The XPS PRO1000 is controlled by using RS-232 or Ethernet connection using telnet
protocol. Commonly used commands are presented and defined in the following tables
covering switching and general system commands.
SWITCHING COMMANDS
Command Syntax
Action
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BRIGHTNESS
BRI <input #> <bright>
Adjusts the brightness of the input signal. RGB
and SD inputs only.
<bright>
is a value from -100 to 100.
CONTRAST
CONT <input #> <contrast>
Adjusts the contrast of the input signal. RGB and
SD inputs only.
<contrast>
is a value from 0 to 200.
HUE
HUE <input #> <hue>
Adjusts the hue of the input signal. SD inputs only.
<hue>
is a value from -180 to 180.
SATURATION
SAT <input #> <sat>
Adjusts the saturation of the input signal. SD
inputs only.
<sat>
is a value from 0 to 200.
CREATEINPUTHOST
CINHOST <slot #> <name>
<hfp> <hs> <hbp> <hact>
<vfp> <vs> <vbp> <vact>
<hfreq> <sync> <phase>
<vpol> <hpol> <interlace>
Creates an input host timing in the designated slot
number, with the specified parameters.
<name>
is limited to 16 characters.
<hfreq>
in Hz.
<sync>
is 3,4, or 5 wire.
<vpol>
is vertical sync polarity; 1 = positive, 0 =
negative.
<hpol>
is horizontal sync polarity.
<interlace>
is 1 = interlaced, 0 = non-
interlaced.
