Black+Decker GL933, Original Instructions Manual

Page: 10 / 12

10
ENGLISH (Original instructions)
Note: Take care not to allow the the line on the spool to
u
Take the new spool and push it onto the boss in the spool
cover. Rotate the spool slightly until it is seated.
u
Align the tabs (17) on the spool cover with the cut outs
(24) in the housing (12).
u
Push the cover onto the housing until it snaps securely
into place.
Warning! If the cutting lines protrude beyond the trimming
blade (11), cut it off so that it just reaches the blade.
Fitting a new piece of heavy duty cutting line
Replacement packs of 10 heavy duty cutting lines are
available from your BLACK+DECKER dealer (cat. no. A6489).
u
Unplug the tool.
u
Keep the tabs (17) depressed and remove the HDL cap
(9) from the housing (12).
u
Remove any dirt and grass from the HDL cap (9) and
housing.
u
Remove the used piece of line from the HDL cap (9).
u
Thread a new piece of line (20) through the eyelets (27) in
either side of the HDL cap.
u
Put the central ferrule (28) in the indicated position
(Fig. P).
u
Warning! Only use the appropriate type of BLACK+DECKER
cutting line.
Troubleshooting
If your tool seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
Warning! Before proceeding, unplug the tool.
Tool runs slowly
u
Check that the spool housing can rotate freely. Carefully
clean it if necessary.
u
Check that the cutting line does not protrude more than
11 cm from the spool housing. If it does, cut it off so that it
just reaches the line trimming blade.
Automatic line feed does not work
u
Keep the tabs depressed and remove the spool cover
from the housing.
u
Pull the cutting line until it protrudes 11 cm from the
install a new spool of cutting line as instructed above.
u
Align the tabs on the spool cover with the cut outs in the
housing.
u
Push the cover onto the housing until it snaps securely
into place.
u
If the cutting line protrudes beyond the trimming blade, cut
it off so that it just reaches the blade.
If the automatic line feed still does not work or the spool is
jammed, try the following suggestions:
u
Carefully clean the spool cover and housing.
u
Remove the spool and check if the lever can move freely.
u
Remove the spool and unwind the cutting line, then wind it
on neatly again as described above. Replace the spool as
instructed.
Protecting the environment
Separate collection. Products and batteries
marked with this symbol must not be disposed of
with normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw materials.
Please recycle electrical products and batteries according to
local provisions. Further information is available at
www.2helpU.com
Technical data
GL933
(Type 1)
Voltage
V
AC
230
Power input W 900
No-load speed
min
-1
7000
Weight kg 3.2
Level of sound pressure:
Sound pressure (L
pA
) 80 dB(A), uncertainty (K) 0.55 dB(A)
Sound power (L
WA
) 94 dB(A), uncertainty (K) 0.55 dB(A)
Vibration total values (triax vector sum) according to EN 50636-2-91:2014:
Vibration emission value (a
h
) 6.0 m/s
2
, uncertainty (K) 1.5 m/s
2