Technical data
Voltage
V
AC
Power Input
W
No-Load Speed
min
-1
Height adjustment
mm
Blade length
mm
Weight
kg
EMax32N/EMax32SN
Type 01
220-240
1200
3500
23-63
320
7.4
EMax32N, EMax32SN
MOWERS
2
ENGLISH
(Original instructions)
Intended use
Your BLACK+DECKER EMax32N and EMax 32SN mowers
have been designed for mowing grass. This tool is intended for
consumer use only.
Warning! Read all of the 'Safety, Maintenance,
Service' manual carefully before operating
this appliance.
Read all of this manual carefully before operating
the appliance.
Features
This appliance includes some or all of the following features.
1. Switch box
2. On/off switch
3. Upper handle
4. Lower handle
5. EdgeMax
6. Grass collection box
7. Grass flap
7a. Box full flap
8. Carry handles
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
The grass box requires assembly before use and comes in 3
pieces.
u
Clip the handle (10) into the lid (11) of the grass box
A). The handle will only one way round.
u
Align the lid (11) onto the base of grass collection box.
Ensure that the 10 guides (12) are aligned
B)
Note: Take extra care when aligning the 2 clips at the rear of
the grass collection box.
u
Push down on the lid to secure all clips. Begin at the back
and ensure that all clips are securely located.
u
Align the plastic pins (13) on the switchbox (1) with the
holes on the handle (14) making sure that the switchbox is
on the top edge of the handle.
u
Slide the plastic pins (13) on the switchbox (1) all the way
through the holes in the handle.
u
Slide the plastic cover (15) into the thin runners in the
switchbox (1).
u
Secure the plastic cover (15) with the 2 screws provided.
u
Insert the ends of the lower handles (4) into the cor-
responding holes in the mower.
u
Press the handle down as far as it will go.
u
Secure the handle using the screws (16).
u
Fit the upper handle (3) to the lower handle (4) using the
knobs (17), washers (18) and screws (19) as shown.
Note: The upper handle can be
in 2 different height
positions.
The motor cable has to be
using the cable restraints.
u
Clip the cable to the upper and lower handle using the
restraint clips (20) as shown.
u
Lift the
(8) and place the grass collection box (7) over
the lugs (21).
u
Loop the cable through the cable restraint to prevent the
extension cable from becoming detached during use.
Warning! Ensure the blade has completely stopped and
disconnect the appliance from the mains.
Warning! Only use the
replacement blade.
Warning! Use heavy-duty gloves to grip the blade.
To remove the blade:
u
Turn the appliance onto its side.
u
Using heavy-duty gloves, grip the blade.
u
Use a 13mm spanner to loosen and remove the blade bolt
(22) by turning the spanner anti-clockwise (ac).
u
Remove the blade (23) and blade bolt (22).
To replace the blade:
u
Offer the blade up to bolt shaft and locate the blade bolt
(22) into the bolt shaft.
2
ENGLISH
(Original instructions)
Summary of Contents for EMax32N
Page 1: ...EMax32N EMax32SN 2 5 8 www blackanddecker com English INDONESIA ...
Page 11: ......
Page 12: ...90629177 02 2016 ...