4
Surge Protector Wall Tap with USB
In the event of malfunction or breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. The Surge Protector Wall Tap must be
connected to a cord having an equipment-grounding conductor and a grounding plug. The
plug must be plugged into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
Improper connection of the equipment grounding conductor can result in a risk
of electric shock. The conductor with insulation having an outer surface that is green with or
without yellow stripes is the equipment grounding conductor. If repair or replacement of the
cord or plug is necessary, do not connect the equipment-grounding conductor to a live
terminal. Check with a qualified electrician or service person if the grounding instructions are
not completely understood, or if in doubt as to whether the wall tap is properly grounded. Do
not modify the plug connected to the wall tap – if it will not fit the outlet, have a proper outlet
installed by a qualified electrician.
FOR GROUNDED, CORD-CONNECTED WALL TAP RATED LESS THAN 15A AND
INTENDED FOR USE ON A NOMINAL 125V SUPPLY CIRCUIT
The Surge Protector Wall Tap is for use on a nominal 125V circuit, and should be connected
to a grounding outlet that looks like that illustrated in sketch a. A temporary adaptor, which
looks like the adaptor illustrated in sketch b, may be used to connect this plug to a 2-pole
receptacle as shown in sketch b if a properly grounded outlet is not available. The temporary
adaptor should be used only until a properly grounded outlet can be installed by a qualified
electrician. The green colored rigid ear, lug, and the like, extending from the adaptor must be
connected to a permanent ground such as a properly grounded outlet box cover. Whenever
the adaptor is used, it must be held in place by the metal screw.
Grounding Instructions
DANGER
:
NOTE:
IN CANADA, THE USE OF A TEMPORARY ADAPTOR IS NOT PERMITTED BY
THE CANADIAN ELECTRICAL CODE. Ensure that the wall tap is connected to an outlet
having the same configuration as the plug.
The protected light should be ON when the power switch is turned ON. If this light goes out
at any time, it means that your surge protector was sacrificed to protect your equipment and
the unit should be replaced.
NOTICE
:
