5
ENGLISH
(Original instructions)
*
Note:
Mains voltage: When connecting to
the mains, it is imperative to verify if the
voltage of the mains matches that of the
power tool. If the mains voltage exceeds
the voltage indicated on the power tool,
the user may become severely injured in
an accident, and the tool may be
damaged. On the contrary, if the mains
voltage is lower than the voltage
required by the tool, the motor may be
damaged as a result. Thus, if it is not
possible to verify the voltage, it is
imperative not to plug in to the power
source.
Safety of others
• This appliance is not intended for use by
persons (including children) with
reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use
of the appliance by a person responsible
for their safety.
• Children should be supervised to ensure
that they do not play with the appliance.
Other risks
Additional residual risks may arise when
using the tool which may not be included in
the enclosed safety warnings. These risks
can arise from misuse, prolonged use etc. In
spite of the application of the relevant
safety regulations and the implementation
of safety devices, certain risks cannot be
avoided.
These are:
• Injuries caused by touching any
rotating/moving parts.
• Injuries caused when changing any parts,
blades or accessories.
• Injuries caused by prolonged use of a
tool. When using any tool for prolonged
periods ensure you take regular breaks.
• Impairment of hearing.
• Health hazards caused by breathing dust
developed when using your tool
(example:- working with wood, especially
oak, beech and MDF.)
Labels on tool
The following symbols are shown on the
tool along with the date code:
Warning!
To reduce the risk of injury,
the user must read the instruction
manual.
Wear safety glasses or goggles when
operating this tool.
Wear ear protection when operating
this tool.
Position of Date Barcode (Fig. C)
The Date Code (12), which also includes the
year of manufacture, is printed into the
housing.
Example:
2017 XX JN
Year of manufacturing
Electrical Safety
Your tool is double insulated;
therefore no earth wire is required.
Be sure to check that the power
supply corresponds to the voltage on
the rating plate. Corresponds.
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised Black and Decker Service
Centre in order to avoid a hazard.
Using an Extension Cable
If it is necessary to use an extension cable,
please used an approved extension cable
that fits the tool’s power input specifications
(please refer to the technical data). The
minimum cross- sectional area of the
conducting wire is 1.5 sq. mm. Cables should
be untangled before reeling up.
Please refer to the following table.
Cable cross-sectional area (mm2) Cable rated current (Ampere)
0.75
6
1.00
10
1.50
15
2.50
20
4.00
25
Cable length (m)
7.5 15 25 30 45 60
Summary of Contents for BDHR26K
