6
ENGLISH
(Original instructions)
7
ENGLISH
(Original instructions)
The tool insert can jam and lead to loss of
control over the power tool.
f) If the plug is not suitable for your socket
outlets, it should be cut off and an
appropriate plug fitted in its place by an
authorized customer service agent.
The
replacement plug.
i) Should have the same fuse rating as the
original plug.
The severed plug must be
disposed of to avoid a possible shock hazard
and should never be inserted into a mains
socket elsewhere.
Assembly
Warning!
Before assembly, make sure that the
tool is switched off and unplugged.
Fitting a drill bit or screwdriver bit
Keyed chuck (Fig. B)
u
Open the chuck by turning the sleeve (6)
counterclockwise.
u
Insert the bit shaft (5) into the chuck.
u
Insert the chuck key (7) into each hole (8) in
the side of the chuck and turn clockwise until
tight.
Removing and refitting the chuck
(Fig. C)
u
Open the chuck as far as possible.
u
Remove the chuck retaining screw, located
in the chuck, by turning it clockwise using a
screwdriver.
u
Tighten an Allen key into the chuck and strike
it with a hammer as shown.
u
Remove the Allen key.
u
Remove the chuck by turning it
counterclockwise.
u
To refit the chuck, screw it onto the spindle
and secure it with the chuck retaining screw.
Use
u
On/off
u
Switch locking for continuous use
u
Speed control for smooth starting
u
Maximum speed control With wheel C the
maximum speed can be adjusted from low to
high
- Switch on the tool
- Lock the switch
- Turn wheel C to select maximum speed
u
Changing direction of rotation
- When not properly set in left/right position,
switch A can not be activated. Change
direction of rotation only when tool is at a
complete standstill
u
Changing bits
- Insert the bit as deep as possible in the chuck.
Do not use bits with a damaged shank
u
Holding and guiding the tool While working,
always hold the tool at the grip area(s)
- Keep ventilation slots uncovered
- Do not apply too much pressure on the tool; let
the tool do the work for you
Selecting the direction of rotation
(Fig. D)
For drilling and for tightening screws, use forward
(clockwise) rotation. For loosening screws
or removing a jammed drill bit, use reverse
(counterclockwise) rotation.
u
To select forward rotation, push the forward/
reverse slider (4) to the centre position.
u
To select reverse rotation, push the forward/
reverse slider to the left.
Warning!
Never change the direction of rotation
while the motor is running.
Switching on and off
u
To switch the tool on, press the speed switch
(2). For tools with variable speed switch, the
tool speed depends on how far you press the
switch. As a general rule, use low speeds for
large diameter drill bits and high speeds for
Summary of Contents for BD10RD
Page 1: ...ENGLISH 3 BD10RD...
