![background image](http://html1.mh-extra.com/html/black-decker-1/bd-36-dwh/bd-36-dwh_instruction-manual_2766285017.webp)
17
Water is
heated,
but not hot
enough.
Voltage less than 240
Volts
The computer chips in your tankless water heater are
programmed with the expectation that your incoming line
voltage is 240 volts. If you have less than 240 volts [i.e.
208V or 220V], it may affect the reading on your water
heater’s digital display and cause it to read slightly higher
than the actual output temperature. To compensate
for this, increase the setting on your water heater if you
need or want hotter water.
Water is too
hot.
The water flow rate
through the heater is
too slow.
Increase the flow rate at the water outlet.
Temperature setting is
too high
Switch to a lower temperature setting.
Water Temperature at
faucet is too hot.
Check for too little flow, or if the set point temperature is
too high. This could possibly indicate a possible internal
part failure. Call us for technical assistance.
Heater
shuts off
during use.
Power outage or
faulty wiring.
Check the power supply. Check the circuit breakers.
If the problem persists, please call us for further technical
assistance.
Water stops
flowing.
Possible Blockage in
water pipes or hoses.
Make sure the main water line valve is fully open, and
there are no obstructions in the water supply line.
Water
temperature
varies from
hot to cold
during use.
Water pressure has
dropped below a
minimum level.
Increase the flow rate from the water supply source.
Summary of Contents for BD-36-DWH
Page 1: ...www bdwaterheaters com Electric Tankless Water Heaters Model BD 36 DWH 118 F temp...
Page 20: ...Notes...
Page 40: ...40 ES Notes...
Page 60: ...60 FR Remarques...