Contact sensor deputy body (L x W x H): 40mmx11mmx11mm
Technical Information
Install on the door or window.
Battery powered.
Easily install with screws or sticker.
Associate with other devices through the gateway.
Compatible with any Z-Wave network.
Including Sensor (Door sensor) to Z-Wave Network
The door sensor can be included to the Z-wave network by pressing the code button.
1) Disassemble the door sensor main body and insert the battery. Make sure the device is located within the
direct range of the controller.
2) Set the controller into the learning mode (see mail controller’s operating manual).
3) Triple click the code button, LED light will flash for 5 times.
4) Door sensor will be detected and included in the Z-Wave network.
5) Wait for the main controller to configure the sensor.
Excluding Sensor (door senor) from Z-Wave Network
1) Make sure the sensor is connected to power source.
2) Set the main controller into the learning mode (see main controller’s operating manual).
3) Quickly, triple click the code button, LED light will flash for 5 times.
4) Wait for the main controller to delete the sensor.
Installation Steps
1.
Door sensor Installation
2.
Battery Installation
Door sensor Installation
Option One
1.
Disassemble the door sensor main body and take out battery, fix it on the door with screws.
2.
Disassemble the door sensor deputy body and fix it on the corresponding door frame position
2.
Option Two
Put the sticker on the bottom of door sensor to fix it on the wall
