20
NETWORK POWER SWITCH JR.
You can set the Network Power Switch Jr. for operating
voltages of 110 to 120 VAC or 220 to 240 VAC via the
voltage selector switch located on the side of the unit.
CAUTION
Make sure that the voltage selector switch is set to the
correct position before applying power.
Connect the device to be powered ON and OFF to the
IEC receptacle marked “Switched Outlet.” A short IEC
320 to North American (NEMA 5-15) power cord is
included for connecting the Network Power Switch Jr.
outlet to the device to be power controlled. You can
connect the Switch to a power strip to simultaneously
control multiple devices.
CAUTION
Make sure that the combined load of all controlled devices
does not exceed 10 amps for 230 VAC or 12 amps for
115 VAC.
Connect the supplied power cord to the connector
labeled “AC Input,” and connect the other end to your
AC source. If a power cord with a different terminating
plug is required, be sure it is properly rated and meets
all required local electrical standards.
Summary of Contents for SWI080A
Page 2: ......