11
CHAPTER 3: Configuration
3. Configuration
Before operating the Micro T1 CSU/DSU, you must configure it to match both the
DTE and Network Interface parameters using the DIP-switch packages on the
bottom of the printed circuit board (see Figure 3-1) or via software using the
RS-232 control port.
Figure 3-1. Bottom view, showing the DIP switches.
Figure 3-2 shows the orientation of the DIP switches with respect to ON/OFF
positions.
Figure 3-2. Closeup of DIP switches.
SW1
SW2
ON
OFF
DIP Switches SW2 and SW1