6
1.877.877.2269
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
CHAPTER 3: SETTING UP YOUR POWER INJECTOR
N
OTE: Use CAT5e or higher Ethernet cables (not included).
1. Using screws, affix the metal feet on the front and/or rear to a flat surface such as a table or wall. See Figure 3-1.
NOTE: The power injector should not use the weight of the Ethernet cables for support.
insert a screw
to secure the unit
to a surface
insert a screw
to secure the unit
to a surface
FIGURE 3-1. LOCATION OF METAL FEET ON THE POWER INJECTOR
Power and data out
Data in
IEC-320 power connector
FIGURE 3-2. PORTS ON THE POWER INJECTOR
2. Connect the 3-pin IEC-320 AC input connector to a power source. Power on the injector.
3. Using CAT5e or higher cable, connect the RJ-45 port on the injector labeled “IN” to your network switch. See Figures 3-2 and 3-3.
4. Connect the RJ-45 port labeled “OUT” on the injector over Ethernet cable to the powered device. See Figures 3-2 and 3-3.
5. The LEDs will light to diagnose the connection. See Tables 4-1 and 4-2.
Power and data to
powered device
Data input from
network switch
AC input
FIGURE 3-3. CABLE CONNECTIONS TO THE POWER INJECTOR
