11
3.2 Installing the Transceiver
1. Turn the power to the network
device off.
2. Connect a BNC T-connector to the
transceiver’s BNC female connector,
then connect thin coax cable to the
T-connector. If only one end of the
T-connector is connected, install a
50-ohm BNC terminator on the other
end.
3. Use a standard AUI cable (50 ft.
[15.2 m] long) to connect an
Ethernet device to the transceiver’s
DB15 AUI connector, or directly
mount the transceiver to a DTE.
4. Turn the power to the network
device back on. Verify that the Power
LED on the transceiver is on.
CHAPTER 3: Installation
Summary of Contents for LE1601A
Page 3: ......
