8
Installation
This chapter gives step-by-step installation instructions for the LB300A, Ethernet Extender.
Selecting a Site for the Equipment
As with any electric device, you should place the equipment where it will not be subjected to extreme
temperatures, humidity, or electromagnetic interference. Specifically, the site you select should meet the
following requirements:
The ambient temperature should be between 0 to 60 degrees Celsius.
The relative humidity should be less than 90 percent, non-condensing.
Surrounding electrical devices should not exceed the electromagnetic field (RFC) standards for IEC 801-3,
Level 2 (3V/M) field strength.
Make sure that the equipment receives adequate ventilation. Do not block the ventilation holes on each side
of the equipment.
The power outlet should be within 1.8 meters of the product.
Connecting to Power
This LB300A, Ethernet Extender is a plug-and-play device.
Connect the supplied AC to DC power adaptor to the receptacle on the rear panel of LB300A, Ethernet
Extender, and then attach the plug into a standard AC outlet with a voltage range from 100 to 240VAC.
Installing in a Chassis
LB300A, Ethernet Extender can be fit into any of the expansion slots on a special designed chassis.
First, install LB300A, Ethernet Extender onto a carrier supplied with the chassis:
Step 1-
Unscrew the carrier from the desired expansion slot on the chassis.
Step 2-
Fit LB300A, Ethernet Extender onto the carrier.
When LB300A, Ethernet Extender is completely seated onto the carrier, insert the carrier to the guide rails of
the expansion slot.