12
1.877.877.2269
BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269
CHAPTER 3: INSTALLATION
LOCATIONS
Please consider the following important points when planning the position of the modules:
• Situate the transmitter module close to the system to which it will be connected and near to a source of mains power. Place the
receiver module in similar close proximity to the peripherals that it will connect with, plus a source of mains power.
• Consult the precautions listed within the supplied safety leaflet.
• Connections do not need to be carried out in the order given within this guide, however, where possible connect the
power in
as
the final step.
Suitable for installation in Information Technology Rooms in accordance with Article 645 of the National Electrical Code and
NFPA 75.
Peut être installé dans des salles de matériel de traitement de l’information conformément à l’article 645 du National Electrical
Code et à la NFPA 75.
TRANSMITTER VIDEO LINK(S)
KVX-HP 400-series modules can transfer various high resolution video
modes via their DisplayPort™ connectors and support up to four video
displays.
TO CONNECT THE VIDEO PORT(S)
1 Connect the supplied DisplayPort link cable between the video socket
1 on the transmitter module rear panel and the primary video output
socket of the host computer.
Optionally connect local video display(s) to video socket 2 on the
transmitter module rear panel.
Video input from
the host computer
1
2
Output to a local video display(s)
MAXIMUM VIDEO RESOLUTIONS
The extenders support the following maximum video resolutions:
Fiber (up to 4km) or CATx (up to 100m
)
1 display at 4096 x 2160 / 60fps
(4K)
2 displays at 2560 x 1600 / 60fps
(WQXGA)
3 displays at 1920 x 1200 / 60fps
(WUXGA)
4 displays at 1920 x 1200 / 60fps
(WUXGA)
WARNING: The local video
display will be at the same
resolution as output from
the RX. Ensure that the local
monitor can handle the
required resolution.
