12
REMOTE PORT USB—1-PORT
3. Installation
3.1 Before You Begin
Before you can install the Remote Port USB, you will need to prepare your site.
1. Determine where the host computer will be located and set up the computer.
2. Determine where you will operate the USB device.
3. If you will be using surface cabling, make sure you have enough Category 5
UTP cabling to connect the two locations.
OR
If you will be using premise cabling, make sure Category 5 cabling is installed
between the two locations with Category 5 information outlets located near
both the computer and the USB device.
4. Install any software required to operate the USB device. Refer to the
documentation for the device as required.
3.2 Install the LEX Unit
1. Place the LEX unit near the host computer.
2. Plug the Type B connector on the USB cable (included) into a USB port on
the LEX.
3. Plug the power adapter into a suitable AC outlet. Or, you can connect the
power adapter to the REX unit.
4. Connect the power adapter to the LEX unit.
5. Plug the Type A connector on the USB cable into the USB port on the
computer.
3.3 Install the REX Unit
1. Place the REX unit near the USB device.
2. Connect the USB device to the USB port on the REX.
3. If the power adapter is not already connected to the LEX unit, connect the
power adapter to the REX unit.