10
FIBERPATH
3. Installation
Figure 3-1
on
page 12
may provide assistance during
installation. Follow these steps:
1. Mount the FiberPath Transmitter at the camera
or source of video to be transmitted. Use the
mounting tabs on the housing or the enclosed
self-adhesive mounting pad.
2. Connect one of the plug-in power supplies to the
input connector on the FiberPath Transmitter. If
you plan to use an external power source, make
sure that it provides regulated 12-VDC ±10%.
Current from this source will not exceed 250 ma.
When power is applied, the red PWR LED
indicator will glow.
NOTE
The negative (-) side of the power input is connected to the
enclosure.
3. Connect the video signal to be transmitted to the
BNC connector on the FiberPath Transmitter, and
the ST fiberoptic cable plug to the transmitter’s
optical connector.
