Black Box AC603A, User Manual

Page: 7 / 16

Mini Cat5 VGA Transmitter w/ Local Port
5
Figure 1 – AC603A Front
2. Installation
2.1 Setup Connections
1. Connect the VIDEO INPUT to the computer's video port using a
male-male VGA cable (not included).
2. If desired, connect a local display to the VGA out port of the
Transmitter unit.
3. Using Category 5 cables connect the RJ45 port of the Transmitter
to the Model AC602A Receiver.
4. Connect the Remote displays to the VGA output port of the
AC602 Receivers.
5. Plug in the supplied Power supply to the Power Input jack of the
Transmitter unit (can also be connected to Receiver instead).
6. Turn on the local and remote displays, then the PC
Note:
If the source is Component Video (YPbPr) an HD15 to 3 RCA
cable will be required for each HD15 connector.
If the source is composite video with stereo audio, a similar
cable will be needed. The RCA connectors are typically yellow
(instead of green) for video and red/white for audio. To transmit
CV and stereo audio, you must set a dip switch per the
following section.