2x1 Compact VGA Switch
9
Auto
If selected, causes the switch to select the input with active
video automatically. The presence of video is determined by
examining the V.Sync signal of the input connectors.
In Auto mode you don’t need to have the pushbutton cord
plugged in. However, if a push button cord is plugged-in, the
button itself cannot be used for switching, but the LED either
stays on or blinks to indicate which input is selected.
Additionally, it is possible to blank the output in auto mode
using the push-button switch (see below)
Auto Mode with Priority:
There are two modes of operation
for the Auto-detection of video. In the default mode (with dip
switches as shown above – TTL switch in off position) no
priority is assigned to either input. Once the switch finds a
video at one of the inputs it selects it and stops scanning until
the currently selected input's video is absent, then the switch
will start scanning again.
If the TTL dip switch is down (on) at the same time as Auto,
then priority is given to input #1. This means that at any time
video is present at input #1 the VS-2 will automatically select
it, regardless of what is happening at input #2. For example if
the Switch is showing an image from input #2 and you plug
in a video signal to input #1, the switch will select #1 right
away.
Auto Mode with Blanking
:. If the blanking dip switch is on
(down) at the same time as Auto then double clicking the
pushbutton will cause the output video to blank out. Click the
button again to restore the output.
