10
Video to PC/HDTV Switching Scaler w/Audio
Figure 3.1
3. Configuration & Operation
3.1 Front Panel
1
1
.
.
Source Selection:
Press the appropriate button to display the
video connected to the rear input connectors on the OSD (On-Screen
Display).
2
2
.
.
Mode:
Press the button repeatedly will toggle through the
following adjustment controls:
Source > Resolution > Output > Aspect > 3D Enhance > Digital NR
Source mode
: While in this mode, press
▲
or
▼
buttons to choose
your desired input source from the Composite Video, S-Video,
Component Video, PC inputs for scaling. If enabled, you can also
BYPASS the PC input through the unit completely. The unit will
bypass the PC in (RGBHV) signal to the output when the power is
turned off. The audio is also bypassed from the PC audio input to
the audio output connector at the last PC volume level selected.
BYPASS is only displayed (by default) in the OSD if ‘PC LOOP
BYPASS’ is enabled in the control software.
Resolution mode:
If the output is set to a RGBHV PC resolution,
press
▲
or
▼
buttons to choose from 640 x 480(VGA), 800 x 600
(SVGA), 1024 x 768(XGA), or 1280 x 1024(SXGA) PC output. If
output is set to a HDTV YPbPr resolution, then press
▲
or
▼
to
choose from 480p, 576p, 720p or 1080i HDTV output.
1
3
5
2
4
6