Black & Decker VP900, User Manual

Page: 8 / 12

8
ENGLISH
Flush out the brush by fitting to the handset in place of
the roller holder, before removing from the tube and
washing the bristles under flowing water.
After cleaning allow all parts to become completely
dry. They may then be stored inside the body of your
Paintmate. Never put wet items inside the body.
Do not remove the flexible seal located between the
roller holder and the paint flow guide.
TROUBLE SHOOTING GUIDE
Fault
Possible cause Remedy
Can’t open Orange button Press orange
handle. is down (on) button to turn off
and unit and release
pressurised. pressure.
Paint leaks 'O' ring Check that the 'O'
from the missing from ring is in place and
Handypack. connector or is free from
contaminated. connector debris
(dried paint).
Connector not Ensure that the
fitted properly. mating surfaces
are free from
debris (dried paint).
Make sure
connector is
pushed in fully and
screwed on (1/4
turn) to a positive
stop.
Paint leaks Tube not fitted Firstly switch off.
from the correctly. Undo threaded nut
connector from handset.
at the handset. Pull down to
expose connection.
Make sure tube is
pushed on to
connector fully.
Retighten nut.
Paint leaks 'O' ring Check that 'O' ring
from top of missing or is in place and is
the handset. contaminated. is free from debris
(dried paint).
Debris on taper Make sure both
fitting.
male and female
taper fittings are
free from debris
(dried paint).
Paint leaks Handypack Return to retailer.
from Handypack. damaged.
Fault Possible cause Remedy
Paint drips Excessively Replace roller.
from roller. worn roller.
Paint flow guide Replace paint
damage.
flow guide.
Flexible Make sure the
connector in connector is in
holder is in- place and fitted
correctly fitted. correctly.
Handset trigger Make sure that you
held on without are painting surface
using roller.
when holding
trigger open.
Paint spurts Air pocket in Prior to connecting
from brush Handypack. tube to the
on startup. Handypack,
squeeze the
Handypack to
expel the air
contained inside.
No paint Trigger not Make sure you
appearing at depressed. are holding down
roller or brush. trigger.
Tube kinked. Check for kinks in
tube: either
straighten or
replace.
Handypack Replace
empty. Handypack.
Pump runs Air bag damaged
continuously. (Contact
authorised
service agent).
Pump not Check correct
operating. batteries are fitted
and are charged.
(If no response
contact authorised
service agent.)
Handset/roller Not using tap Follow cleaning
messy to clean. adapter. instructions.
Not kept unit Follow cleaning
assembled instructions.
during cleaning.
Handset/brush Trigger not Follow cleaning
tube will not depressed instructions.
flush. during cleaning.