VEC1031CBD
USER’S MANUAL
& WARRANTY INFORMATION
IMPORTANT SAFETY INFORMATION, SAVE THESE INSTRUCTIONS
TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND
THIS INSTRUCTIONAL MANUAL. THIS MANUAL CONTAINS IMPORTANT
INFORMATION REGARDING THE OPERATION AND WARRANTY OF THIS
PRODUCT. PLEASE RETAIN FOR FUTURE REFERENCE.
www.vectormfg.com
4140 S.W. 30th Ave., Ft. Lauderdale, FL 33312 U.S.
Toll Free: (800) 618-5178
8
TROUBLESHOOTING
Unit Fails to Jump-Start
• Make sure unit’s power switch is in the ON position.
• Check that Jump-Starter/Inflator has a full charge.
• Make sure a proper polarity cable connection has been established (see “Using
the Unit as a Jump-Starter,” page 3).
12 Volt Outlet Fails to Deliver Power
• Make sure a proper 12 volt adapter connection has been established.
• Check that the unit has a full charge.
12 Volt Outlet Shuts Off
Disconnect unit and allow to cool for 10 minutes.
Note:
When pulling more than 5 amps from the 12 volt outlet, unit will shut off.
LED Area Light Does Not Come On
• Check that the unit has a full charge.
SPECIFICATIONS
Jump-Start Clamps:
300 amps – heavy-duty copper
Jumper Cables:
#6 AWG welding cable
Instant Amps:
300
5 Second Amp:
225
Battery High Density AGM:
12 volt, 9 Ah, sealed, lead-acid
Worklight Bulb:
Long-life LED
Accessory Outlet Protection: 5 amps, self-resetting breaker
START-IT
®
Jump-Starter/Inflator/
Rechargeable Power Supply
VEC1031CBD_ManualEN_032906 4/6/06 3:17 PM Page 8
