• Separate the nozzle section from the sprayer
motor by pressing the release button on the
motor housing as shown in
figure N
.
• Grasp the nozzle section and twist until it is
90 degrees to the housing, then pull straight out
(
figure O
).
• If using water based material, clean the nozzle
section by running water through pickup tube
inlet as shown in
figure P
. If using oil based
materials, clean pickup tube inlet with the
appropriate cleaning solution. Repeat until
sprayer is completely clean.
• Dry all parts thoroughly.
• Properly dispose of cleaning solution.
• Place a drop of household oil onto the metal
ball in the check valve
(
figure Q
).
IMPORTANT: Lubricating the ball
in check valve, after cleanup, will help to
prevent it from sticking which can clog the
valve and prevent adequate flow of spray
material.
NOTE:
When reassembling, place metal ball
end of check valve into sprayer.
• Reassemble sprayer (
figure R
).
NOTE: The
spray tip can only go in one way. The notch
on the spray tip, shown in figure S must
align with the recess in the threads of the
sprayer.
10
P
N
O
Q
R
S
