background image

2

SAfEty guiDELinES / DEfinitionS

DANGER:

 Indicates an imminently hazardous situation which, if not avoided, will result in death or 

serious injury.

WARNING:

 Indicates a potentially hazardous situation which, if not  avoided, could result in death or 

serious injury.

CAUTION: 

Indicates a potentially hazardous situation which, if not avoided, may result in minor or 

moderate injury.

CAUTION:

 Used without the safety alert symbol indicates potentially hazardous situation which, if not avoided, 

may result in property damage.

RISK OF UNSAFE OPERATION.

 When using tools or equipment, basic safety precautions should 

always be followed to reduce the risk of personal injury. Improper operation, maintenance or 

modification of tools or equipment could result in serious injury and property damage. There 

are certain applications for which tools and equipment are designed. Black & Decker strongly 

recommends that this product NOT be modified and/or used for any application other than for which 

it was designed. Read and understand all warnings and operating instructions before using any tool or 

equipment.

iMPoRtAnt SAfEty inStRuctionS

GENERAL SAFETY WARNINGS AND INSTRUCTIONS FOR ALL INVERTERS

READ All INSTRUCTIONS

WARNING:

 Read all instructions before operating product. Failure to follow all instructions listed 

below may result in electric shock, fire and/or serious injury.

• 

Avoid dangerous environments.

 Don’t use appliances in damp or wet locations. Don’t use 

appliances in the rain.

• 

Store idle appliances indoors. 

When not in use, appliances should be stored indoors in dry, and 

high or locked-up place – out of reach of children.

• 

Disconnect appliances. 

Disconnect the appliance from the power supply when not in use,  

before servicing, and when changing accessories such as blades and the like.

• 

Proper cooling is essential when operating the inverter. 

Do not place the unit near the vehicle’s 

heat vent or in direct sunlight.

• 

Use of accessories and attachments. 

The use of any accessory or attachment not recommended 

for use with this appliance could be hazardous. Note: refer to the accessory section of this manual 

for further details.

• 

Check damaged parts. 

A part that is damaged should be properly repaired or replaced by 

manufacturer.

• 

Extension cords. 

Make sure your extension cord is in good condition. When using an extension cord, be 

sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause 

a drop in line voltage resulting in loss of power and overheating. The following table shows the correct 

size to use depending on cord length and nameplate ampere rating. If in doubt, use the next heavier 

gauge. The smaller the gauge number, the heavier the cord.

Minimum Gauge for Cord Sets

Volts  

Total Length of Cord in Feet (Meters)

120V 0-25  26-50 

51-100  101-150

 

(0-7.6m)  (7.6-15.2m)  (15.2-30.4m) (30.4-45.7m)

240V 

0-50 

 51-100 

101-200 

201-300

 

(0-15.2m) (15.2-30.4m) (30.4-60.9m)  (60.9-91.4m)

Ampere Rating

More 

Not more   

American Wire Gauge

Than Than 

 0 - 

 6 

18 

16 

16 

14

  6 - 

10 

18 

16 

14 

12 

10 - 

12 

16 

16 

14 

12

12 - 

16 

14 

12 

Not Recommended

• 

Outdoor use extension cords.

 When an appliance plugged into this unit is used outdoors, use only 

extension cords intended for use outdoors and so marked. 

Note that this inverter is not intended to 

be used outdoors.

3

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK:

• 

Do not make any electrical connections or disconnections in areas designated as 

IGNITION  

PROTECTED.

 This includes DC cigarette lighter type plug connection. This unit is NOT approved for 

ignition protected areas.

• 

NEVER 

immerse the unit in water or any other liquid, or use when wet.

• 

Do not insert foreign objects into the AC outlet or the USB outlet.

WARNING: TO REDUCE THE RISK OF FIRE:

• 

Do not replace any vehicle fuse with one of a rating higher than recommended by the vehicle 

manufacturer. This product is rated to draw 8 amperes from a 12 volt vehicle accessory outlet. 

Ensure that the electrical system in your vehicle can supply this without causing the vehicle fuse to 

open. This can be determined by making sure the fuse in the vehicle that protects the outlet is rated 

higher than 8 amperes. Information about the vehicle fuse ratings are typically found in the vehicle 

operator’s manual.

• 

If the vehicle fuse opens repeatedly, do not continue to replace it. Discontinue use of the vehicle 

accessory outlet and locate the source of the overload. NEVER patch the fuse with tin foil, wire, or 

the like, as this may cause serious damage elsewhere in the electrical circuit or cause a fire.

• 

Do not operate near flammable materials, fumes or gases.

• 

DO NOT expose to extreme heat or flames. 

CAUTION: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE: 

• 

Remove appliance plug from outlet before working on the appliance.

• 

DO NOT attempt to connect or set up the unit or its components while operating your vehicle. Not 

paying attention to the road may result in a serious accident.

• 

Always use the inverter where there is adequate ventilation. Do not block ventilation slots.

• 

ALWAYS turn the inverter OFF by disconnecting it from the DC accessory outlet when not in use.

• 

Make sure the nominal powering voltage is 12 volts DC, center connection positive (+).

• 

Do not install in engine compartment — install in a well ventilated area.

• 

Do not use with positive ground electrical systems.* Reverse polarity connection will result in a 

blown fuse and may cause permanent damage to the inverter and will void warranty.

• 

 

*The majority of modern automobiles, RVs and trucks are negative ground. 

• 

Keep in mind that this inverter will not operate high wattage appliances or equipment that produce 

heat, such as hair dryers, microwave ovens and toasters.

• 

Do not open the inverter — there are no user-serviceable parts inside.

• 

Do not use this inverter with medical devices. It is not tested for medical applications.

• 

Keep away from children. This is not a toy!

• 

Install and operate unit only as described in this Instruction Manual.

• 

Do not use this inverter on a watercraft. It is not qualified for marine applications.

• 

Check unit periodically for wear and tear. Do not disassemble the unit; return it to the manufacturer 

when service or repair is required. Opening the unit may result in a risk of electric shock or fire, and 

will void warranty.

• 

Read And Understand This Instruction Manual Before Using This Unit.

SAvE thESE inStRuctionS

WARNING: TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:

 Follow these instructions 

and those published by the manufacturer of any equipment you intend to use with this inverter. 

Review cautionary markings on these products.

INTRODUCTION

Thank you for purchasing the 

Black & Decker PI120P 120 Watt Power Inverter with USB Charging 

Port

. This inverter can be used to operate personal electronics such as: laptop computers, digital/video 

cameras, MP3 players, cell phones, tablets, and more. It can also be used to recharge 110/120 volt AC 

devices that have an appropriate recharging adapter with a standard North American two- or three-prong 

plug. Please read this Instruction Manual carefully before use to ensure optimum performance and to 

avoid damage to this product.

Summary of Contents for PI120P

Page 1: ... PORT INstruction Manual Catalog Number PI120P SAVE THIS MANUAL FOR FUTURE REFERENCE Cat PI120P May 2013 Copyright 2013 Baccus Global Printed in China Thank you for choosing Black Decker PLEASE READ Before returning this product for any reason ...

Page 2: ...te lighter type plug connection This unit is NOT approved for ignition protected areas NEVER immerse the unit in water or any other liquid or use when wet Do not insert foreign objects into the AC outlet or the USB outlet WARNING TO REDUCE THE RISK OF FIRE Do not replace any vehicle fuse with one of a rating higher than recommended by the vehicle manufacturer This product is rated to draw 8 ampere...

Page 3: ...n harm the unit Thermal Shutdown Protection The inverter will automatically shut down when the unit becomes overheated Overload Short Circuit Protection The inverter will automatically shut down when an overload or short circuit occurs Note The Power Fault LED Indicator will light red to indicate a fault condition before automatic shutdown occurs Rated Versus Actual Current Draw of Equipment Most ...

Page 4: ...quate snow free signal and that high quality shielded antenna cable is used Common Power Output Problems Possible Cause Recommendation Battery voltage below 10 5 volts Recharge battery or check DC power supply Equipment being operated draws too much power Reduce load to maximum 100 watts Inverter in thermal shutdown condition Allow inverter to cool down Ensure there is adequate ventilation around ...

Reviews: